SEAJET PellerClean is a foul release silicone coating for propellers, stern gear, shafts, rudders and trim tabs. This foul release product is environmentally friendly, does not contain biocide and provides long lasting foul-release property in both fresh and saltwater environments.
SEAJET PellerClean is designed to withstand up to an average speed of 40 knots. Suitable for DIY use as well as professional use.

• Two-coat, environmentally friendly system
• Two-part zinc chromate free patented epoxy primer with excellent adhesion
• Silicone-based foul-release coating which provides an ultra-smooth, ultra-slippery surface
• Provides long-term protection against fouling in both fresh and saltwater environments.
• Any fouling removes itself from the surface when underway.
• Inactive boats or less than five knots – quick wash or sponging will remove any surface fouling

Applications:

• Propellers
• Shafts
• Struts
• Rudders
• Trim Tabs

Specifications:

Water Types: Salt water, Fresh water, Brackish water
Maximum Speed: Average 40 knots, maximum speed can be higher.
Application Method: Roller, Brush

Small Kit -1750 ml

Coverage: Quantity in small kit is sufficient to treat 40ft² (3.88m2). 

Elevate your boating experience with Seajet PellerClean. This video introduces our innovative foul-release coating, designed to be biocide-free and eco-friendly, setting new standards in sustainable marine care. Discover the unparalleled performance of PellerClean, which ensures a consistently pristine voyage without compromising our commitment to the environment. Watch as we demonstrate the effectiveness of PellerClean in maintaining superior hull cleanliness and efficiency. Learn about the cutting-edge technology that makes this possible and see firsthand the benefits of choosing a greener solution for boat maintenance.

How to apply SEAJET PELLERCLEAN?

Step 1: Surface treatment

Remove all contamination and any existing coating from the substrate by using a combination of scraper, abrasive paper, and abrasive pads.

Remove the dust by fresh water washing.

Step 2: Creating a surface profile

 

Abrade the substrate using a medium grade abrasive paper (P80, 80 grit, etc.) to create a surface profile.

Rinse the surface with any SEAJET thinner.

After rinsing, do not touch the substrate without wearing gloves to avoid contamination.

Step 3: Application Primer

 

Pigments in Pellerclean Primer Base may be settled. Stir until homogeneous.

After mixing the base, add the Pellerclean Primer Hardener and mix thoroughly for 3 minutes.

Apply two coats of Pellerclean Primer on the substrate.

The second coat may be applied immediately after the first.

Maximum overcoating interval between the primers is 7 days. Allow a minimum drying time of 15 minutes, but no longer than 30 minutes, before moving on to step 4.

Step 4: Application Clear coat

 

Apply a minimum of two coats of Pellerclean Clear Coat.

The second coat may be applied immediately after the first. To obtain maximum performance, use all Pellerclean Clear Coat provided in the kit.

Repair and recoating

 

For re-coating existing Pellerclean: If the existing system is intact, you may re-coat after fresh water washing.

Do not apply primer over clear coat. Re-coating may be required annually at high cavitation areas.

To repair damaged areas, follow application instruction steps 1-4.